[BUG] (Tramming Wizard probing extremes)

[eblieb]

Did you test with a precompiled firmware?

Yes, and the problem still exists.

Bug Description

The Automatic Tramming Wizard is only probing the most extreme points (almost off the plate) which is causing issues with my glass bed.

Bug Timeline

No response

Expected behavior

Probing points closer to above the adjustment knobs

Actual behavior

Probing points close to x0 y0, x0, y248, ect.

Steps to Reproduce

No response

Version of Professional Firmware

20240122

Printer model

Ender 3 V2

Electronics

4.2.2

LCD/Controller

No response

Other add-ons

No response

Bed Leveling

UBL Bilinear mesh

Your Slicer

Other (explain below)

Host Software

None

Additional information & file uploads

Using CRTouch

[mriscoc]

Hi, this is not a general printer support forum. Many problems can be easily solved by reading the firmware Wiki please check the calibration guide.

This Issue Queue is for firmware bug reports and development-related issues, and we prefer not to handle user-support questions here. For best results getting help with configuration and troubleshooting, please use the following resources:

Enhanced support in Patreon: https://www.patreon.com/mriscoc

Free community support:

• Github discussions: https://github.com/mriscoc/Ender3V2S1/discussions
• Facebook: https://www.facebook.com/groups/professionalfirmware
• Telegram: https://t.me/ender3v2s1firmware
• Reddit: https://www.reddit.com/r/Ender3v2Firmware
• Discord: https://discord.gg/3dprinters